Installation
Mounting location, sensors and limit switches.
- Connecting limit switches (pop-top roof, bed)How Switchy automatically stops the motor of a lift bed, pop-top roof or slide-out as soon as it has reached the very top or bottom.
- Handover: recording the actual state of the configurationHow van converters and specialist workshops use the self-diagnosis to record the actual state at handover and quickly clear up later questions.
- Installing temperature sensorsUp to 5 temperature sensors on Fluidy Pro: how to connect them, how to wire them and where they make sense in the camper.
- Installing the water level sensorStep by step: drill a hole, hang the sensor in the tank, connect it and calibrate it in the dashboard. Applies to fresh, grey and black water.
- Installing the water pressure sensor and leak cableWhere the pressure sensor goes in the water pipe, how to lay the leak cable and what to watch out for in frosty weather.
- Where modules belong and where not: choosing the installation locationWhich installation locations are suitable for Camper Jarvis modules, which four places are off-limits and what to do if a device overheats.
We don't have anything on that yet. Get in touch, we're happy to help.
Your question isn't covered?
Write to us and we'll answer personally.
